System Diagrams

Compatibility Lists  Installation Guides Specification Sheets System Diagrams Voltage Drop IES Files

The following diagrams are provided as example system designs. Always review each component installation guide for detailed and up-to-date wiring instructions.
Please contact Customer Support additional system diagrams.
Always Install in accordance with NEC and local regulations.

____________________________________________________________________

Plug-In Adapter With DC Accessory Diagram

Plug-In-Adapter-Wiring-Diagram

____________________________________________________________________

Basic Hard-Wired On/Off Diagram

Traditional-ON_OFF-Wiring-Diagram

____________________________________________________________________

12V-24V REIGN Dimmer Switch Diagram

12-24V-REIGN-DIMMER-Wiring-Diagram

____________________________________________________________________

Magnetic Dimmable Driver Diagram

Magnetic-Dimmable-Driver-Wiring-Diagram

____________________________________________________________________

0-10V Dimmable Driver Diagram (No Relay Module)

0-10V-Control-System-Diagram-(No-Relay-Switch)

____________________________________________________________________

0-10V Dimmable Driver Diagram (With Relay Module)

0-10V-Control-System-Diagram-(With-Relay-Switch)

____________________________________________________________________

Lutron® Hi-Lume® LTE Dimmable Driver Diagram

Lutron-Hi-Lume-A-Series-(LTE-Model)-System-Diagram

____________________________________________________________________

Lutron® Hi-Lume® L3D Dimmable Driver Diagram

Lutron-Hi-Lume-A-Series-(L3D-Model)-System-Diagram

____________________________________________________________________

Hard-Wired RGB Color Controller Diagram

RGB-Hard-Wired-Wiring-Diagram

____________________________________________________________________

K-RANGE 24™ Tunable White LED Tape Light Diagram

24V-K-Range-Hard-Wired-Wiring-Diagram

____________________________________________________________________

DMX Controller Diagram

DMX-General-Diagram

 

* Driver may not require a fault ground connection. Refer to driver specifications for additional information.
** Install a compatible Class 2 constant voltage driver. It is recommended to load the driver no more than 80% its labeled rating for maximum longevity.
*** Install a Class 2 constant voltage driver compatible with a low voltage PWM controller. It is recommended to load the driver no more than 80% its labeled rating for maximum longevity.
**** Determine the number of low voltage outputs of the driver when installing multiple PWM controllers/dimmer switches. No more than one PWM controller/dimmer switch can be attached to a single output of the driver.
† Install a compatible magnetic low voltage dimmer switch. See dimmer switch manufacturer installation guide for complete wiring instructions.
†† Dimmable drivers require a compatible magnetic low voltage dimmer switch to supply the driver and fixture with appropriate input voltage. Do not test or install directly connected to an AC power source or On/Off switch. It is recommended to load the driver no more than 80% its labeled rating for maximum longevity. See dimmer switch manufacturer specifications for minimum load recommendations.
‡ Refer to driver or controller specifications for a compatible junction box.
‡‡ See fixture specifications for maximum series run limits.
§ See inline accessories specifications for maximum amperage ratings.
§§ See fixture specifications for a compatible adapter cable.